Dust pre-filter OXYLINE OXYPRO X7N11 P2 R D

OXYLINEMOXYPRO X7N11 P2 R D DUST PRE-FILTER meets the standards EN 14387:2004+A1:2008 (respiratory protective devices - gas filters and combined filters - requirements, testing, marking). The X7N11 P2 R D dust filter is replaceable and reusable, for twin-filter half masks and masks. It can be used as a pre-filter by fitting it with the X501 cover on the X701 A1, X702 A1E1, X703 ABEK1 gas filters. It can be used for longer than one work shift. It is recommended not to exceed three work shifts. When combined with a suitable twin-filter half mask or full face mask, the X7N11 P2 R D filter protects the respiratory system against non-toxic and moderately toxic water-based aerosols (dust, smoke, mist). The X7N11 P2 R D filters have no bayonet connector, so they must only be used with the X501 cover in combination with the X701 A1, X702 A1E1, X703 ABEK1 gas filters. They can be used with X6 and X7 series half masks and X8 series full face masks. OZNAKOWANIA/ IDENTYFIKACJA ZAGROŻENIA TYPE P2: colour white/ solid particles, dusts, aerosols/ protection against gases or vapours at a volume concentration in air not exceeding 0.5% (5.000 ppm) R: can be used for longer than one work shift D: the filter has passed the optional dolomite dust clogging test INSTRUKCJA MONTAŻU Place the X7N11 pre-filter on the X701 A1, X705 A2 or X702 A1E1 or X703 ABEK1 gas filter with the printed side facing inwards Place the X501 cover on the filter and press the cover onto the gas filter until you hear a click Check that the X7N11 pre-filter covers the entire surface of the gas filter To replace the pre-filter, remove the cover by pulling it out of the catches Filter+pre-filter+pre-filter cover/ reverse the procedure to dismantle the product