Gas filter OXYLINE OXYPRO X703 ABEK1

The OXYLINE OXYPRO X703 ABEK1 GAS FILTER meets EN 14387:2004+A1:2008 (respiratory protective devices - gas filters and combined filters - requirements, testing, marking). The X703 ABEK1 gas filter is a reusable product for twin-filter half masks and masks. The X703 ABEK1 gas filter with a bayonet connector protects against organic vapours and gases with a boiling point above 65°C (brown), inorganic vapours and gases except carbon monoxide (grey), sulphur dioxide and acid vapours and gases (yellow), ammonia and ammonia derivatives (green) at a volume concentration in air not exceeding 0.1%. The swept-back design provides a better field of vision. The X703 ABEK1 gas filter has a bayonet connector allowing connection to X6 and X7 series half masks and X8 series full face masks. OZNAKOWANIA/ IDENTYFIKACJA ZAGROŻENIA TYPE A1: brown/ organic gases and vapours with a boiling point above 65°C, e.g. solvents, hydrocarbons, etc./ low sorption capacity gas filters, designed to protect against gases or vapours at a volume concentration in air not exceeding 0.1% (1.000 ppm) TYPE B1: grey/ inorganic gases and vapours, e.g. chloride, cyanide, formaldehyde, hydrochloric acid/ low sorption capacity gas filters, designed to protect against gases or vapours at a volume concentration in air not exceeding 0.1% (1.000 ppm) TYPE E1: colour yellow/ acid gases and vapours, e.g. sulphur dioxide etc./ low-capacity gas filters, intended for protection against gases or vapours at a volume concentration in air not exceeding 0.1% (1.000 ppm) TYPE K1: colour green/ ammonia and organic ammonia derivatives/ low-capacity gas filters, intended for protection against gases or vapours at a volume concentration in air not exceeding 0.1% (1.000 ppm) INSTRUKCJA MONTAŻU Read the instructions for use carefully and make sure the filtering elements have been correctly selected for the hazards Make sure the product is not damaged, contaminated, deformed or dirty, and that it is in its original packaging If the product is contaminated, deformed or past its expiry date, it must be replaced Align the plastic connector of the filtering elements correctly with the socket in the half mask or mask Press in and turn clockwise Repeat the procedure when fitting the second filter OGRANICZENIA/ PRZECHOWYWANIE Do not use in environments where the oxygen concentration is below 19.5% or in the presence of unknown gases Storage: in the original packaging together with the instructions, without filtering elements attached, at a temperature from -20°C to +30°C and humidity RH<80% Protect from direct sunlight Adapt to the working environment, contaminant concentration and type of work Shelf life: gas filters that are properly stored and in their original packaging have a shelf life of 5 years from the date of manufacture. The date of manufacture is shown on the gas filter and on the packaging