Full face mask OXYPRO X8 (BAYONET) CL2- SILICONE

FULL FACE MASK OXYPRO X8 (bayonet) CL2 - SILICONE. Meets the standard EN 136:1998 (Respiratory protective devices - Full face masks - Requirements, testing, marking). The twin-filter silicone full face mask of the X8 series consists of a body, a large panoramic visor with peripheral vision, two durable bayonet connectors with inhalation valves and gaskets, and head harness straps. The mask design allows it to be combined with elements that remove harmful substances in the form of aerosols (dust, smoke, mist), vapours and gases, and both forms together. The relatively low weight of the X8 series mask and the twin connectors for attaching purifying elements increase work efficiency. X8 series masks are available in sizes M and L. The mask is resistant to damage. The visor of the X8 series mask is scratch-resistant and anti-fog. The panoramic face cover, a polycarbonate visor, maximises light inside the mask and ensures optimal visibility while protecting against impacts. Head harness straps with 4-point attachment ensure an excellent seal and a stable position during work. The X8 series full face mask can be used with T-BM P2 R, T-BM A P2 R, T-BM P3 R, T-BM A P3 R, X2000-AG P3 R filters, X793 P3 R, X793C AP3 R capsule filters, X701 A1, X702 A1E1, X703 ABEK1 gas filters and X70523 A2P3 R D, X70923 A1E1 P3 R D, X70926 ABEK1 P3 R D combined filters. INSTRUKCJA MONTAŻU Fitting the filter: align the filter connector with the filter holder in the mask Press in and turn the filter clockwise as far as it will go Repeat the procedure for the second filter Loosen the four straps of the head harness Place the mask on the face, first on the chin and then over the rest of the face, moving hair aside so that the seal is in contact with the skin only Once the mask is on the face, pull the head harness over the head as shown in the drawing Adjust the straps in the following order: neck, temples and forehead Do not overtighten. Try to find a comfortable and secure fit. Strap tension can be reduced by pulling out the buckle tabs OGRANICZENIA I PRZECHOWYWANIE Do not use in environments where the oxygen concentration is below 19.5% or in the presence of unknown gases Store in the original packaging together with the instructions, without filtering elements attached, at a temperature from -20°C to +30°C and humidity RH<80% Protect from direct sunlight CZYSZCZENIE I DEZYNFEKCJA Remove the filters before cleaning the mask Clean the mask with a damp cloth and immerse it in a warm water solution whose temperature must not exceed 50°C, using a neutral detergent if necessary Rinse with warm water and air-dry in a contaminant-free environment NIE CZYŚCIĆ ZA POMOCĄ ROZPUSZCZALNIKÓW, SILNYCH DETERGENTÓW LUB PRODUKTÓW ROPOPOCHODNYCH