Half mask OXYLINE OXYPRO X6 TPR RUBBER (BAYONET)

HALF MASK OXYLINE OXYPRO X6 TPR RUBBER (BAYONET) meets the standard EN 140 (respiratory protective devices - half masks and quarter masks - requirements, testing, marking). Gas half mask made of thermoplastic TPR rubber from the Oxyline X6 series for use with two purifying elements. The reusable Oxyline X6 half mask has two bayonet connectors. It protects the respiratory tract against a wide range of gases, vapours and dusts. Its fitted ergonomic shape ensures optimal vision and it is compatible with eye protection PPE. It is highly resistant and durable. Evenly distributed weight on the user's face ensures comfort and a tight seal, so the half mask stays perfectly in position during various activities. The X6 half mask can be used with filters T-BM P2 R, T-BM A P2 R, T-BM P3 R, T-BM A P3 R, X2000-AG P3 R, capsule filters X793 P3 R, X793C AP3 R, gas filters X701 A1, X702 A1E1, X703 ABEK1 and combined filters X70523 A2P3 R D, X70923 A1E1 P3 R D, X70926 ABEK1 P3 R D. INSTRUKCJA MONTAŻU Fitting the filter: align the plastic filter connector with the filter holder on the mask, press in and turn the filter clockwise as far as it will go, repeat the procedure for the second filter Adjust the plastic part of the head harness straps (cradle) so that it fits comfortably on the head Place the plastic cradle over the head so that the arrow next to the face drawing (on the cradle) points upwards Hold the ends of the lower elastic straps with one hand, and with the other slide the mask onto the face, covering the mouth and nose Take the ends of the straps, place them behind the neck and fasten them together. (Fig.4) Adjust the strap tension by pulling the strap ends until a secure and comfortable fit is achieved. Strap tension can be reduced by pushing out the back of the buckle OGRANICZENIA I PRZECHOWYWANIE Do not use in environments where the oxygen concentration is below 19.5% or in the presence of unknown gases Store in the original packaging together with the instructions, without filtering elements attached, at a temperature from -20°C to +30°C and humidity RH<80% Protect from direct sunlight CZYSZCZENIE I DEZYNFEKCJA Remove the filters before cleaning the half mask Clean the half mask with a damp cloth and immerse it in a warm water solution whose temperature must not exceed 50°C, using a neutral detergent if necessary Rinse with warm water and air-dry in a contaminant-free environment NIE CZYŚCIĆ ZA POMOCĄ ROZPUSZCZALNIKÓW, SILNYCH DETERGENTÓW LUB PRODUKTÓW ROPOPOCHODNYCH